Strip Holders

J442 Almen Strip Holders
Aero-Almen Strip Holder
Magnetic Almen Strip Holder

The Electronics Incorporated Almen test strip holders are industry standard J442 Almen holders. Special styles can be custom ordered including a variation with end feet. Alternate configurations of Almen holders are available on special request. All holders meet dimensional surface requirements of SAE J442 and are hardened to Rockwell C 58 or higher. Screws for strip attachment are supplied with each block. Additional screws are available.

All holders are thru-hardened to minimum HRc 58 so  the surface can be re-finishied to maintain surface flatness requirements.

Threaded and non-threaded holders are also available — choose the design of Almen Holder that makes mounting your test strips easiest for you.

Note: MIL-S-13165 has been cancelled. The drawings of strips, holder and gage were in inches while SAE J442 measurements are metric. EI can supply to MIL-S-13165 at an additional cost. Please contact EI for more information.

Top J442 Almen Strip Holders
	Holder threaded w/ 5mm screws $65.72     P/N 970071.T
	Non-threaded holder w/ screws and nuts $65.72     P/N 970071
	Holder with flanges $72.41     P/N 970073
	5mm screws for threaded holder $28.12/box of 100     P/N 970074
Top Aero-Almen Strip Holder
	Three-strip holders for aircraft paint stripping using Aero-Almen strips.  More aircraft paint stripping products. $278.49     P/N 99114
Top Magnetic Almen Strip Holder
	Special magnetic holder for use with the 3M Roto Flap peening process. More flapper peening products. $190.46     P/N 999256